« previous next »
Pages: [1]   Go Down

Author Topic: Clutch tube mount  (Read 3165 times)

0 Members and 1 Guest are viewing this topic.

Offline Thomas

  • *
  • Posts: 414
  • Karma: 2
Clutch tube mount
« on: May 27, 2010, 10:52:51 AM »
I picked up a factory rebuild swing axle tranny and the only differance I noticed was the clutch tube holder is not part of side plate. Should I use the side plate from my trans or try and find a bolt on bracket used on newer swing axles. Also where does the backup switch mount on this tranny. Thanks Thomas



Logged
58 Beetle

Offline Bruce

  • Full Member
  • Posts: 2914
  • Karma: -65458
Re: Clutch tube mount
« Reply #1 on: May 27, 2010, 08:48:00 PM »
You should get the bracket from a later gearbox.  I'm sure CIP sells it too.
You can't swap the side covers, that would alter the bearing preload, and the ring gear backlash.
Logged

Offline Thomas

  • *
  • Posts: 414
  • Karma: 2
Re: Clutch tube mount
« Reply #2 on: May 31, 2010, 10:55:24 AM »
Thanks for the info Bruce, the guy I got the tranny from dropped off a bracket for me. Cheers Thomas
Logged
58 Beetle
Pages: [1]   Go Up
« previous next »