« previous next »
Pages: [1]   Go Down

Author Topic: Distributer Drive Gear  (Read 1096 times)

0 Members and 1 Guest are viewing this topic.

Offline shovel80

  • Full Member
  • Posts: 162
  • Karma: 1
Distributer Drive Gear
« on: November 18, 2007, 09:55:19 AM »
OK i have taken it out of my old block (I used the pencil trick and it worked fine). And now I need to get it into my new Block,what is the procedure to get it back in or is it self aligning ??
Thanks Dave
Logged
Never ride faster than your guardian angel can fly.

Offline Hansk

  • Full Member
  • Posts: 1638
  • Karma: 4
Distributer Drive Gear
« Reply #1 on: November 18, 2007, 12:58:04 PM »
Pretty straight forward. Make sure the motor is TDC #1 firing , two shims , then just imagin where the dist. and drive(they fit together only one way) must go while set at #1, allow for some clockwize rotation as it drops in , and drop the drive in.  
(then don't turn the motor without a dist. in)
Logged
Big fat black fastback
Pages: [1]   Go Up
« previous next »