no there is no bearings in the kit ,i think they are about $11.00 each .got mine at advance bearing in richmond.my carbs were in the same condition after sitting for 10 years.once you press the throttle shaft out you can pull the bearings and that is where you will find all the buildup-strip them and all the parts and let it all soak in a bucket of carb cleaner,no blasting will not clean plugged passageways.all parts will come out looking like a million bucks.WARNING INSTALLING THE THROTTLE SHAFT AND BEARINGS IS VERY TRICKY .you must centre the shaft and bearings at the same time as the fit is tight.you may want too freeze the shaft beforehand and warm the carb housings,then you can install one bearing,flip carb and support under the installed bearing with a socket .press in throttle shaft.make sure everthing is 100% lined up ,then support the end of the throttle shaft and install last bearing.kind of a 1/2/3 step thing.hope it makes sense.there is some pictures of my carbs in a post below about adapters.good luck and be patient.