Author Topic: Help Mac Users! (Read 1559 times)

James Buchan · « **on:** July 08, 2006, 05:53:06 PM »

I have a macbook pro and I just updated the firmware (it said I should...) Now my JVC 30Gb DV camera is not being recognized.... Any ideas? It is connected via a USB port.

GRK · « **Reply #1 on:** July 08, 2006, 06:37:02 PM »

What program do you use to open camera? Sounds to me like a preferance issue?Do you have a program called image capture? if so click on it and go to preferances. there should be a spot that say's something like when camera conected ,open: choose the program you want opened when camera is hooked up. This may sound stupid but after you upgrades did you re start the puter?

Gary

James Buchan · « **Reply #2 on:** July 08, 2006, 07:25:40 PM »

I did restart it, the camera has a hard drive instead of tapes so I can read it like an external Hdd - it now doesn't recognize it at all in finder. how would i check that my usb ports are working?

Chris · « **Reply #3 on:** July 08, 2006, 08:13:08 PM »

plug something else in them like a mouse or a printer.

James Buchan · « **Reply #4 on:** July 08, 2006, 08:53:13 PM »

DOH - I dumbed down when I was using the Mac - Thanks C , I'll try that.

Needles · « **Reply #5 on:** July 08, 2006, 10:38:14 PM »

Go to Applications] Utilities]Disk Utility. Run it. Restart
If that fails check out...

http://www.apple.com/support/macbookpro/

If ya still can't figure out.... post on this discussion board http://discussions.apple.com/category.jspa...?categoryID=190

James Buchan · « **Reply #6 on:** July 09, 2006, 07:55:25 AM »

Fixed! Turned out that the camera file structure needed service - found out when I opened the view screen on it an saw the message.

Thanks all!

jim martin · « **Reply #7 on:** July 09, 2006, 09:45:13 AM »

good now get it all loaded ,i'm dieing to see it