Author Topic: Langley U Blast (Read 1361 times)

dirtydeedss · « **on:** January 07, 2006, 11:25:29 AM »

has anybody blasted a vw chassis at langley u blast before??
how much did it cost??

Russ · « **Reply #1 on:** January 07, 2006, 11:32:57 AM »

i think Matt did
he will probably chime in,i though it was around a couple hundred bucks

Matt · « **Reply #2 on:** January 07, 2006, 01:08:00 PM »

langley u-blast doesn't have the facilities for a chassis, check this thread

http://www.airspeedparts.com/community-for...03&hl=sandblast

vwboop · « **Reply #3 on:** January 07, 2006, 01:09:20 PM »

Sandman in Abbotsford is very reasonable (actually friggin cheap!) and you don't have to do it. It's a terrible job & it'll take you longer than a pro too. We did a pan (never again), as it cost us more to do it ourselves (after sand and rental), than having the Sandman do it.

dirtydeedss · « **Reply #4 on:** January 07, 2006, 01:49:50 PM »

what about those 50 dollar sand guns with a hopper on top
do they work good??

Hillbilly · « **Reply #5 on:** January 07, 2006, 01:59:43 PM »

Quote

what about those 50 dollar sand guns with a hopper on top
do they work good??

Only if you are doing a small item.......You could do your whole car but the amount of sand you would use in the 40 or 50 hours of sandblasting it woild take you.......not to mention a new copressor when your done....have it done with a pressurized unit. In the long run much cheaper B)
Bill

Author Topic: Langley U Blast (Read 1361 times)

Russ

Matt