« previous next »
Pages: [1]   Go Down

Author Topic: An fitting. What size for breather?  (Read 3214 times)

0 Members and 1 Guest are viewing this topic.

Offline Jeremy

  • *
  • Posts: 977
  • Karma: 3
An fitting. What size for breather?
« on: April 17, 2012, 01:11:09 PM »
What size AN fittings are the common size for breather systems? AN-8 or AN-10?

I was going to weld an AN fitting to a stock oil fill/breather but couldn't decide on a size when I was a PA today.

 Jeremy
« Last Edit: April 17, 2012, 01:48:50 PM by Jeremy »
Logged
'59 Beetle
'59 Single Cab

Offline owdlvr

  • Dave Hord
  • *
  • Posts: 1422
  • Karma: 10
    • Classic Car Adventures
Re: An fitting. What size for breather?
« Reply #1 on: April 17, 2012, 03:26:38 PM »
-8, -10 and -12 are all common depending on engine size.

In the VW world it seems -8 is most common, and more then sufficient for street.

-Dave
Logged
--
'71 Type 1 - Rally Car Project
'75 Type 1 - Heirloom
'95 F150 - Unfortunate daily driver...

Offline Jeremy

  • *
  • Posts: 977
  • Karma: 3
Re: An fitting. What size for breather?
« Reply #2 on: April 18, 2012, 09:12:47 AM »
Thanks Dave.
Logged
'59 Beetle
'59 Single Cab

Offline Loadedagain

  • Full Member
  • Posts: 7
  • Karma: 0
  • AirSpeed Forum Member
    • stenhouse racing
Re: An fitting. What size for breather?
« Reply #3 on: April 24, 2012, 02:01:13 PM »
as dave said... i've always used -8 stuff on mine. highly unlikely you'll get much restriction on a breather line.
Logged
Pages: [1]   Go Up
« previous next »