« previous next »
Pages: [1]   Go Down

Author Topic: Wtd: Nut Insert For Engine Case  (Read 979 times)

0 Members and 1 Guest are viewing this topic.

Offline Trevor P

  • Full Member
  • Posts: 942
  • Karma: 3
Wtd: Nut Insert For Engine Case
« on: April 14, 2008, 08:54:24 PM »
In need of the nut insert that goes into the engine case above cyl 3 on the engine side of the bellhousing (for the engine to trans mounting bolt). The captive one that is in place on all the later doghouse shroud equipped engines. Perhaps someone has a scrap engine case that they could liberate this from?
« Last Edit: April 14, 2008, 08:55:14 PM by Trevor P »
Logged
'53 Barndoor single cab
'57 Cal-look oval 2332cc / Berg 5
'70 911T

Offline BUSDADDY

  • Full Member
  • Posts: 1273
  • Karma: 7
  • Like potato chips, you can't have just one
Re: Wtd: Nut Insert For Engine Case
« Reply #1 on: April 18, 2008, 09:14:08 AM »
JB weld on a nut.
Logged
RUST NEVER SLEEPS

Offline Trevor P

  • Full Member
  • Posts: 942
  • Karma: 3
Re: Wtd: Nut Insert For Engine Case
« Reply #2 on: April 18, 2008, 08:50:33 PM »
I found one..thanks anyways.
Logged
'53 Barndoor single cab
'57 Cal-look oval 2332cc / Berg 5
'70 911T
Pages: [1]   Go Up
« previous next »