Author Topic: 34-pict With 009 Dist. (Read 4209 times)

Mike Scott · « **on:** August 09, 2003, 03:57:05 PM »

Ok, I've been battling with this thing for weeks. Are the flat spots I experience during acceleration normal with a stock 160DP using a 009 dist.?

Geoff · « **Reply #1 on:** August 09, 2003, 04:52:38 PM »

Yup, 009 will give a bog when used with that carb. Some fine tuning can help eliminate it but it can take a while.

65_bug · « **Reply #2 on:** August 09, 2003, 05:52:25 PM »

I had the same problem with my set up (34 pict with 009). I cured the problem by buying a centre-mount dellorto 45 DRLA. It fixed all flat spots and hesitations.

mackerr · « **Reply #3 on:** September 04, 2003, 01:55:31 PM »

I also had this problem and seemed to solve it after adjusting the idle mixture at a shop with a gas analizer. The mixture was adjusted to pass air-care and after passing was re adjusted to eliminate the flat spot.

egspot · « **Reply #4 on:** February 16, 2006, 07:16:42 PM »

How do you adjust for air care with ( 34poct & 009) that setting?

Emilio

Chris · « **Reply #5 on:** February 16, 2006, 07:25:38 PM »

Quote

How do you adjust for air care with ( 34poct & 009) that setting?

Emilio

with a gas analyzer.

buggysam · « **Reply #6 on:** February 16, 2006, 07:47:29 PM »

i put a rivet in the hole in the throttle plate to improve the airflow thru the idle circit .... it seemd to help lots