this friday i spent the time too patch the donner frt clip and tack it into place.
it fit real well and was a lot simpler than i imagened.
you can see some of the areas i patched and filled in.
but its level and straight in the quarters
have too do a bit of custom work for a fuel cell ,but it went well .
there it is in its new home,fits great and will fill in each side of the tank
with a aluminum trim panel.who said you can't stuff a cell up front.
time too let the master fabricator TATE WESTERMAN in for the real work
man he does nice work !!!!!
here is the sweet patch panel from airspeed .again very nice!!!
this is what it looks like from the inside.
just need seam sealer and its done
first the airspeed fiberglass hood gets a 10 out of 10 !!!
you can't use a riv nut as the cast in metal is too deep so the compression area would be in fiberglass
and not metal. so no problem just tap it .!!! problem solved.
here is a shot of it on the car.works and fits great !!!!
on too the airspeed fiberglass fenders. right frt fender gets a 10 out of 10 for fit and instilation.
the left frt fender gets a 7 out of 10 . inner lip is a bit short and angle where it meets body
is too steap a little scarry too sintch in i will have too glass on a piece too support it ,as well it sure didn't won't too take the shape of the frt clip at rear section of fender .strange considering the other side was a snap.
you can see were it was a bit short.
but most inmportant is both fenders fit dead on and look fantastic on there ,
.
here is the million dollar shot.
nice!!!!
and i still have 1 1/2 travel as well as i now have 1 3/4 fender clearance .!!
hood and fender line up nice
thanks too the help of silas !! again thanks for stopping by
we were able too hoist a pan. as you can see good shape just needs a clean up.
things seam too be moving at a great pace as well as on track .
will clean up the lower pan and coat it with por15 then reassemble it and hopefully a painted shell will meet with it soon,
again fantastic fiberglass products as the fit and outer apperance is number 1 !!!
thanks again silas for helping out .
looks like i need more parts .
next weld in frt apron and finnish small metal jobs and that will be it for me then tate can finnish it up