« previous next »
Pages: [1]   Go Down

Author Topic: 22mm Link Pin and Roller Cage Needed  (Read 808 times)

0 Members and 1 Guest are viewing this topic.

Offline riff raff

  • Full Member
  • Posts: 49
  • Karma: 0
22mm Link Pin and Roller Cage Needed
« on: February 28, 2012, 04:51:26 AM »
Discovered one seized link pin and badly corroded roller bearing cage (late split bus beam with 22mm link pins) on the beam I am putting together for Daisy, the Humboldt Co-op Single Cab.
Anybody have a good used single link pin (or two) and roller cage(s) they could part with?
Could also use a half dozen shims as several of these are pooched.
Thanks
« Last Edit: February 28, 2012, 04:53:26 AM by riff raff »
Logged

Offline billybob57

  • *
  • Posts: 298
  • Karma: 0
Re: 22mm Link Pin and Roller Cage Needed
« Reply #1 on: February 28, 2012, 08:16:14 AM »
Got my spindles back from Wagens West and in a bag was my Link Pins and Needle bearings
One of my Bearings was broke apart and the rollers were in a pile..:(
i emailed Nate and he sent me 1 brand new roller bearing cage and a cpl of washers...
couldnt hurt to email him and see if he has any spares forsale...Good Luck!     Bill
Logged
Pages: [1]   Go Up
« previous next »