AirSpeed VW Community Forums

Technical => Engine Tech Forum => Topic started by: Russ on October 17, 2005, 07:08:12 PM

Title: Mounting Engine
Post by: Russ on October 17, 2005, 07:08:12 PM

stupid question but when mounting the engine on the engine stand the studs come out the bottom do you remove the studs and just run a short bolt into them.or do you just put a sleeve over it and tighten it on.
the arms do not line up for the top holes.
thanks russ

Title: Mounting Engine
Post by: James Buchan on October 17, 2005, 07:16:30 PM

Use the upper and lower mounts on the same side of the engine - for the stud I put some over size nuts inbetween as spaces to make it snug up.
 

Title: Mounting Engine
Post by: josh on October 23, 2005, 11:38:09 AM

I cut a piece of SS tube for a spacer.