AirSpeed VW Community Forums

General Forums => Air Speed Lounge => Topic started by: James Buchan on September 17, 2003, 05:16:40 PM

Title: Hey Matt Was It Any Good?
Post by: James Buchan on September 17, 2003, 05:16:40 PM

Hey wondering if that door pillar support thingy had enough meat on it for you? Alot of cancer showed up after I had blasted it.

Title: Hey Matt Was It Any Good?
Post by: Matt on September 17, 2003, 05:31:00 PM

Ya, there was a bit of rust, but where I need its ok. Thanks

Matt

Title: Hey Matt Was It Any Good?
Post by: Matt on September 17, 2003, 05:42:17 PM

actually I'm goin out to play with it right now!!!

Matt

Title: Hey Matt Was It Any Good?
Post by: James Buchan on September 17, 2003, 05:44:24 PM

With it huh .......take some rags with ya, don't mess up you clean garage.

Title: Hey Matt Was It Any Good?
Post by: Matt on September 17, 2003, 08:39:29 PM

did the most work on that car in a long time!!! cut out the old rotten door hinge pillar, repaired the hinge support and started to fit the new outer skin.......that new Miller sure works good!! :D  :D  :D

Matt

Title: Hey Matt Was It Any Good?
Post by: silas on September 17, 2003, 11:56:02 PM

hey matt. just curious as to what kind of miller welder you have?

Title: Hey Matt Was It Any Good?
Post by: Matt on September 18, 2003, 07:01:01 AM

Miller 135. 110 volt.

Matt

Title: Hey Matt Was It Any Good?
Post by: red snapper on September 18, 2003, 07:09:11 AM

Its about friggin time! ;)  

Title: Hey Matt Was It Any Good?
Post by: Matt on September 18, 2003, 06:51:15 PM

Quote

Its about friggin time! ;)

blow me

Title: Hey Matt Was It Any Good?
Post by: red snapper on September 19, 2003, 07:30:11 AM

Quote

blow me

NO!!!!!!!!! :P