AirSpeed VW Community Forums

General Forums => Classifieds => Topic started by: paolo on May 24, 2017, 08:36:33 PM

Title: FS: 1600 Dual Port Parts - Main and 17th Vancouver ** All sold **
Post by: paolo on May 24, 2017, 08:36:33 PM

I've got the following, taken off my engine after running it for about 500 milers last summer:

1641 Slip-Fit P/C's, about 500 miles on them - $100

Pair of New Chinese Stock 1600 Heads, about 500 miles on them - $200 for the pair

Dual Port Manifold with EMPI 34 PICT/3 Carb - $50

2 x 1600 Heater Boxes - Free

1600 Rear Apron Tin with hole for Heat Hose, wide type - Free

Doghouse Shroud, sandblasted, 1 cm tear at throttle tube hole $40

Pair of Finned Aluminum Valve Covers $20

Lower Sled Tins - Free

Many Thanks

Title: Re: FS: 1600 Dual Port Parts - Main and 17th Vancouver
Post by: blacksc on May 24, 2017, 10:05:58 PM

What can you tell me about the heads?

Title: Re: FS: 1600 Dual Port Parts - Main and 17th Vancouver
Post by: paolo on May 24, 2017, 11:29:49 PM

You can check with AVR but I'm pretty sure they are these ones:

https://www.cip1.ca/ProductDetails.asp?ProductCode=VWC-043-101-355-CKHL

500 miles or so on them. Car ran great but I had to pull cases apart due to low oil pressure at idle.

Title: Re: FS: 1600 Dual Port Parts - Main and 17th Vancouver
Post by: blacksc on May 25, 2017, 07:50:09 AM

I wonder if I can bolt these onto my 1200.

Title: Re: FS: 1600 Dual Port Parts - Main and 17th Vancouver
Post by: paolo on May 25, 2017, 08:36:51 AM

I would research this but I doubt it; Even 1300 to 1600 poses challenges... I may be wrong.

Title: Re: FS: 1600 Dual Port Parts - Main and 17th Vancouver
Post by: OldnShitty on May 25, 2017, 12:09:37 PM

Hey, are the heater boxes still available?

Title: Re: FS: 1600 Dual Port Parts - Main and 17th Vancouver
Post by: paolo on May 26, 2017, 08:59:42 AM

Yup, they are... PM me pls for address....