AirSpeed VW Community Forums
Technical => Transmission Forum => Topic started by: Black-Back on July 29, 2004, 01:34:30 PM
-
When I take a tight turn at slower speeds I hear a humming......no more like a low drone type of noise, I've got pennzoil 80/90 gear oil in it.
It was re-built 5 years ago by Lou in NV, its bone stock. I don't think leaving it sit for some time would cause anything to go wrong would it? Any ideas?
Mike
-
axle bearing?
-
Hmmmm.......... good call.........
-
IRS or swing?
If a trans doesn't turn for 5 years it can rust inside. The gear oil runs off leaving exposed bare steel. It takes months for the surface to become vulnerable.
-
Swing axle. I figure the internals may be a little gummed up, after such a long time unused, however after driving for the first 2 weeks or so i did change the oil in it just to be sure, and there wasn't any foriegn crap in the oil.
Wen I had Lou rebuild it for me he didn't replace the axle bearings so that may be the problem.
Thanks,
Mike