AirSpeed VW Community Forums

General Forums => Classifieds => Topic started by: Alp on October 03, 2011, 01:53:05 PM

Title: parting out 1970 Westfalia
Post by: Alp on October 03, 2011, 01:53:05 PM
I am bringing a Westy home tomorrow and want to part it out.  The interior westy stuff is my main interest.  Geoff may grab the back cab corners.  After that most everything will be up for grabs.  Don't want this to linger at the house so be quick or it is off to the crusher!
Title: Re: parting out 1970 Westfalia
Post by: Alp on October 03, 2011, 07:48:26 PM
Hey Nedshred couldn't email you back for some reason.  They should be there for you  the front windsheild will be gone already other than that I think the rest is there
Title: Re: parting out 1970 Westfalia
Post by: riff raff on October 06, 2011, 12:48:49 PM
e mail sent
Title: Re: parting out 1970 Westfalia
Post by: 72vwtype2 on October 06, 2011, 01:19:41 PM
Is the front nose salvageable?

Thanks.
Title: Re: parting out 1970 Westfalia
Post by: Alp on October 06, 2011, 01:21:18 PM
how much of the front nose?  The bottom has the typical rot but up a bit higher seems fine.
Title: Re: parting out 1970 Westfalia
Post by: Geoff on October 06, 2011, 04:42:48 PM
I  looked at the nose yesterday and it's very clean with no windsheild rot, behind the bumper area may be a little soft but it was hard to tell.
Title: Re: parting out 1970 Westfalia
Post by: 72vwtype2 on October 07, 2011, 08:54:06 AM
I need to replace the entire front nose. So as long as the bottom is semi soild. I might be interested.

Thanks.
Title: Re: parting out 1970 Westfalia
Post by: Batan on October 07, 2011, 05:52:11 PM
How is the front bumper? Mine's got kinks in it and I'd rather just get a straight one that screw around with fixing it. Also, I need the slider door lock too, mine's buggered.
Title: Re: parting out 1970 Westfalia
Post by: Alp on October 07, 2011, 05:57:02 PM
no front bumper as for locks I am going to sell them as a complete set.
Title: Re: parting out 1970 Westfalia
Post by: PICTUP on October 09, 2011, 09:56:55 PM
PMed