AirSpeed VW Community Forums
General Forums => Classifieds => Topic started by: buddy boy on September 10, 2010, 07:19:33 PM
-
looking for a good set of 4 seals ...thanx!
-
i remember reading somewhere that corvair seals work with little mod on our cars , i think they have a groove in them so they can pop in and not move , any one have tricks or any info on a beeter seal ?
-
for seals try AVR or CIP...or heck...even lordco.
your wires dont have any? not sure what brand of wires you have...but does the cap part of the wire (the part that goes on plug) stick out past the engine tin? and if so can you not slide the seal over that part of the wire and have it butt up against the tin to provide a good seal?
-
Back when I had a car...
I used the stock ones that where thin and soft, if you push them into the hole in the tin, the air keeps them tight against the tin and they stay put.
Mirko
-
mine are the cheapy one\s i guess, the this and floppy , dont make a good seal , i have heard of ppl pushing them all the way in so they touch the inside of the tin , i think thats what mirko is saying.