AirSpeed VW Community Forums

General Forums => Air Speed Lounge => Topic started by: 1blk66 on June 13, 2008, 05:54:51 AM

Title: Beam narrowing - Brad Purser where are you??
Post by: 1blk66 on June 13, 2008, 05:54:51 AM

Hey gang I'm looking for a narowed BJ Beam for my 66 and spoke with Brad at last years GCVWS but have misplaced his phone number.
Any body have his contact info or if he's on here his anyone know what his "handle" is, so I can get in touch with him?
 
Alternatively, anyone have a complete beam out there? I'm not looking to do any body mods and I do want to run shocks, just want to install my CB wide 5 disc kit I got recently and I understand they will kick out the wheels a inch and a half or so. Basically I think a 2 inch narrow would work. How narrow can I go without mods and still run shocks?  ???

Any comments always appreciated.

Thanks
Todd   

Title: Re: Beam narrowing - Brad Purser where are you??
Post by: Chris W on June 13, 2008, 07:53:35 AM

You could always just run the CB narrowed beam.

http://www.cbperformance.com/catalog.asp?ProductID=1434 (http://www.cbperformance.com/catalog.asp?ProductID=1434)

Title: Re: Beam narrowing - Brad Purser where are you??
Post by: Alp on June 14, 2008, 08:44:41 AM

check with Dirtydeeds he had one made up and for sale.  I think it was a 2" narrowed beam.  It was under the classifieds.

Title: Re: Beam narrowing - Brad Purser where are you??
Post by: speedbuggy on June 14, 2008, 05:57:38 PM

I don't think a China made?? CB beam even comes close to comparing to a beam built by Brad...he'll likely be around this weekend..