AirSpeed VW Community Forums

General Forums => Air Speed Lounge => Topic started by: shovel80 on November 18, 2007, 09:55:19 AM

Title: Distributer Drive Gear
Post by: shovel80 on November 18, 2007, 09:55:19 AM

OK i have taken it out of my old block (I used the pencil trick and it worked fine). And now I need to get it into my new Block,what is the procedure to get it back in or is it self aligning ??
Thanks Dave

Title: Distributer Drive Gear
Post by: Hansk on November 18, 2007, 12:58:04 PM

Pretty straight forward. Make sure the motor is TDC #1 firing , two shims , then just imagin where the dist. and drive(they fit together only one way) must go while set at #1, allow for some clockwize rotation as it drops in , and drop the drive in.  
(then don't turn the motor without a dist. in)