AirSpeed VW Community Forums
General Forums => Air Speed Lounge => Topic started by: stan62vw on March 04, 2007, 10:19:52 AM
-
Hey all you air heads, looking for advise on lowered spindle install on king link set up got the passenger side all set up .First question are you supose to bend the brass/copper washer between the two bolts on the hub to lock or just stays as is.Secound question when i went to go to install drivers side the bolts on hub they won't go on the spindles are brand new from C B Preformance am i over looking something i feel as if i should not have to tap and dye something brand new any input would be great :rockon:
-
bend that washer. there should be 2 tangs on it....bend one tang back and away from you over the inner nut and the other tang toward you over the outer nut.
first, thoroughly inspect the threads on the nut and on the spindle to make sure that they are not damaged. the spindle on the drivers side is a left hand thread....so lefty tighty-righty loosey (left to tighten-right to loosen). if that doesnt work, use the nuts on the passengers side spindle (the ones that fit) on the drivers spindle and see if that works.
good luck. B)
-
thankyou Silas i thought you had to bend those washers i will go out and try reverse thread and mix nuts around :rockon:
-
how did it go stan? any luck?
-
Hey there Silas, your advice :rockon: I had to take nuts off passenger side put on drivers side Finished today looks so sweet got to adjust brakes and bleed emm So happy with results thank you for the heads up on those nuts another add on done time to start thinkin of another one :rockon: