Recent Posts

Pages: [1] 2 3 ... 10
1
Classifieds / WTB:FOUND
« Last post by Lanny on May 08, 2025, 07:53:16 AM »
Looking for original standard Beetle front hood hinges with the coil support springs
2
Classifieds / WTB 65 up standard Beetle rear glass
« Last post by Lanny on May 06, 2025, 07:29:36 AM »
Looking for a rear window for my 66. No heater. Must be mint, no major scratches.
3
Classifieds / Re: Want to buy; Split case axle, found
« Last post by JoeT on May 05, 2025, 07:11:46 PM »
Found , Thanks guys,I forgot your names but thanks for helping out
4
Classifieds / Re: Want to buy; Swing axle tranny
« Last post by JoeT on May 05, 2025, 07:09:52 PM »
Thanks Lanny, for sure let me know if it becomes available
5
Classifieds / FS: Gene Berg Stinger ignition system
« Last post by Lanny on May 05, 2025, 01:24:29 PM »
Text 604-202-7810 for pix and details
6
Classifieds / WTB-FOUND
« Last post by Lanny on May 01, 2025, 06:49:15 AM »
OEM only, wires plug in the side of the switch.
7
Classifieds / Re: Want to buy; Swing axle tranny
« Last post by Lanny on May 01, 2025, 06:45:34 AM »
I have a transaxle coming out of a running/driving 1960 Beetle, I'll have to see if the customer wants to keep it as i'm swapping it to a later setup.
8
Classifieds / Want to buy; Swing axle tranny
« Last post by JoeT on April 29, 2025, 01:41:17 PM »
Anyone have a 1966 or older swing axle tranny? Can be a split case too. Any condition except known to be broken will do.
If you have one to sell let me know thanks
Text is best 778 985 1375

Joe Tolkamp
9
Classifieds / Want to buy; Split case axle found thanks guys
« Last post by JoeT on April 29, 2025, 01:37:38 PM »
Anyone have a axle shaft for a splitcase transaxle. The drivers side end thread has been ground down and crudely and cruelly threaded to 1 inch NC. (not even metric) so I need to replace it. I'm not sure if both sides are the same inside. If you have one to sell let me know thanks.
Text  7789851375 is best

Joe
10
Classifieds / Re: WTB 60-67 Beetle radio block off with trim
« Last post by Lanny on April 22, 2025, 06:08:04 AM »
I am. Will let you know asap. Thanks!
Pages: [1] 2 3 ... 10