« previous next »
Pages: [1]   Go Down

Author Topic: Sleeve lifter bores for UDO lifters?  (Read 1966 times)

0 Members and 1 Guest are viewing this topic.

Offline 711302

  • Junior Member
  • Posts: 1
  • Karma: 0
  • AirSpeed Forum Member
Sleeve lifter bores for UDO lifters?
« on: July 10, 2012, 01:27:34 PM »
I am building a EFI/Turbo 2110 with a NEW bubble top aluminum case. I am using Udo Becker tool steel lifters and wondered if I engine gurus think I should sleeve the lifter bores?
Logged

Offline Trevor P

  • Full Member
  • Posts: 942
  • Karma: 3
Re: Sleeve lifter bores for UDO lifters?
« Reply #1 on: July 11, 2012, 10:20:53 PM »
Wouldn't think it neccessary with an AL case.
Logged
'53 Barndoor single cab
'57 Cal-look oval 2332cc / Berg 5
'70 911T

Offline Cameron

  • *
  • Posts: 525
  • Karma: 1
Re: Sleeve lifter bores for UDO lifters?
« Reply #2 on: July 12, 2012, 01:19:14 PM »
I agree with Trevor.
Probably not needed, unless the lifters are already sloppy in the bores.
Logged


It's an insane world out there... and I'm proud to be part of it!

  

Offline josh

  • *
  • Posts: 2248
  • Karma: -17
Re: Sleeve lifter bores for UDO lifters?
« Reply #3 on: July 16, 2012, 12:39:20 PM »
I have a 2332 with a rampy FK46 in it and dude that built it had the bores in mag case bushed in aluminum not bronze........first time i've heard of ally being used to bush but seems to hold up
Logged
55 ragtop T1
56 kombi T2
Pages: [1]   Go Up
« previous next »