I'm looking for some good original hardware for my '56 beetle project. I'm not too concerned with which markings (ie: Kamax, Dorn, Knipping) as long as the threads are good and not too much corrosion.
Here's my list, I'll purchase any quantity you've got that's less or more than what I need or if you've got hardware you'd rather not go through I can buy that as well.
QTY: 4 - M10x50mm - Bolts for body to pan mounting through front cross-member (Napoleon's Hat).
QTY: 2 - M10x25mm - Bolts for body to pan mounting through rear quarter support to rear shock tower.
QTY: 18 - 14mm head M8 "Special" bolts - Pointed body to pan bolts, The original ones I have that survived are 30mm long from underside of head to end of point.
QTY: 36 - 14mm head M8x18mm - Fender mounting bolts.
QTY: 4 - 14mm head M8x25mm - Fender to running board bolts.
QTY: 20 ish each - M10 Bolts 10mm and 15mm lengths.
I have about 2 1/2 sets of original body to pan pointed bolts with 13mm heads that I can trade/sell. Plus this table of stuff can be traded/sold.
-KlassicFab Beetle rear RH quarter (new)
-Misc Cip1 1956 beetle brake lines (new)
-2x beetle 3 pin badges 113 853 601 B (original - used driver condition)
-90mm 40hp Bosch Dist.Cap 211 905 207 (original - used unknown working condition)
-Cip1 shifter bushing and clip (new)
-CSP weld in beam adjusters (new)
-Cip1 shifter stop plate (new)
-Misc dash/shift knobs, black shift knob is 7mm, white shift knob is 10mm (original used condition)
-Wolfsburg West weld in battery tie down plate (new)
-Rubber boots for clutch/throttle cable exit on chassis (1new 1nos)
-Shift boots later style VW markings inside (new)
-Wolfsburg West roller pedal (new)
-Oval window section, underside louver/decklid hinge panel removed and a section under the window on the inside is removed (original/used)
Thanks for looking!
Joe
