« previous next »
Pages: [1]   Go Down

Author Topic: Mounting Engine  (Read 1097 times)

0 Members and 1 Guest are viewing this topic.

Russ

Mounting Engine
« on: October 17, 2005, 07:08:12 PM »
stupid question but when mounting the engine on the engine stand the studs come out the bottom do you remove the studs and just run a short bolt into them.or do you just put a sleeve over it and tighten it on.
the arms do not line up for the top holes.
thanks russ
Logged

Offline James Buchan

  • Full Member
  • Posts: 6403
  • Karma: -51
Mounting Engine
« Reply #1 on: October 17, 2005, 07:16:30 PM »
Use the upper and lower mounts on the same side of the engine - for the stud I put some over size nuts inbetween as spaces to make it snug up.
 
Logged

Offline josh

  • *
  • Posts: 2248
  • Karma: -17
Mounting Engine
« Reply #2 on: October 23, 2005, 11:38:09 AM »
I cut a piece of SS tube for a spacer.
Logged
55 ragtop T1
56 kombi T2
Pages: [1]   Go Up
« previous next »