Ok, so lots more work done on the bug
I had to make some C channel for the engine seal tin on the apron, I ended up doing that at school and it turned out very well, almost looks factory
I finished spot welding to new engine seal trays
After I got my engine in I threw my new fenders on and get the tail lights on, it’s really starting to look like something
After I got it all on I noticed that my apron had more of a curve then my fenders did, it was unacceptable so out came the tin snips and torches
Turned out pretty nice
It definitely fits much nicer
Then after looking at the back of my car for so long I noticed the tail lights looked funny, turns out that the driver side was 1/2 inch higher than the passenger so I welded the old holes and made new ones to imitate the other side
Now it is better
After that my dad and I reamed my door hinges for the pins
These pieces are 1 thousandth over the pin size
And the door is 1 thousandth under
Got the doors on today and it looks really good