Author Topic: 14mm Press In's W/ Empi Wide 5's (Read 2265 times)

James Buchan · « **on:** January 10, 2007, 11:57:48 AM »

Is anyone running knock-off 5 spokes with press in 14mm studs? If so any clearence issues and what type of nut is it (ball seat etc)

Thanks

Matt · « **Reply #1 on:** January 10, 2007, 03:28:16 PM »

With the 5 spokes I had on the notch last summer, I just used the thread in wheel studs with some loctite. IIRC the nuts were shouldered. Shane has them now, hardware and all.

James Buchan · « **Reply #2 on:** January 10, 2007, 04:41:28 PM »

Hmmm Thanks Matt

Bubba · « **Reply #3 on:** January 10, 2007, 09:31:57 PM »

I have 5 spokes on the 64 with threaded/loctited studs...they use washers under the nuts.

Csaba

James Buchan · « **Reply #4 on:** January 13, 2007, 08:16:28 AM »

Those threaded ones are 12mm though, i've now gone to 14mm - I am just going to give it a try and see what happens - I'll report back...