« previous next »
Pages: [1]   Go Down

Author Topic: merger question  (Read 1217 times)

0 Members and 1 Guest are viewing this topic.

Offline egspot

  • *
  • Posts: 3301
  • Karma: 0
    • http://www.cardomain.com/id/egspot
merger question
« on: September 17, 2008, 06:06:11 PM »
I just want to confirm before I start.

My current muffler is not good enough for my engine, I have a 1 5/8 merger that comes toguether as male pipes insert into female pipes, I have been assured that there is no needs for additional clamps etc. I am palnning to install it with a hidden muffler,

Should I be concern about the joining areas and leaks?
Logged

Offline Randy

  • Formerly Tikitime
  • *
  • Posts: 542
  • Karma: 4
Re: merger question
« Reply #1 on: September 17, 2008, 07:05:09 PM »
I had a similar situation. I used a Stainless sway bar clamp and cut a small slit in the female pipe before clamping. It looks good and seams to work fine.

http://www.cip1.ca/ProductDetails.asp?ProductCode=C26%2D401%2D141S
Logged
Pages: [1]   Go Up
« previous next »